Re: Unable to clone the machine...
Please have a look followings link...http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1018194Cheers, Yours Udin
View ArticleRe: The VMware ESX server does not have persistent storage
André, I upgraded firmware and ESXi to 5.1, now I can see the datastores using the ssh CLI . When I do: vim-cmd vmsvc/power.on 32Powering on VM:Power on failed Now I'm downloading the vSphere client...
View ArticleRe: The VMware ESX server does not have persistent storage
It worked!!!!!, thank you very, very much Andre.
View ArticleRe: The VMware ESX server does not have persistent storage
You are welcome.So now you have new, recommended firmware on the hosts, additional storage and even an upgraded ESXi host. That's what I call taking advantage of a disaster André
View ArticleRe: Changing Host IP Address
In your first question I think if you change the IP address in your same subnet it's may not case any problem but I don't know what other service is running that server. like if you have Ipsec VPN then...
View ArticleRe: SNMP ESXi 4.1.2 configuration
You better write a script for this. That will give result.Cheers, Yours Udin
View ArticleRe: How to Backup Esxi Host Configuration
Here is a nice article, have a look... http://blogs.vmware.com/esxi/2009/10/backing-up-your-esxi-host-configuration.htmlCheers, Yours Udin
View ArticleRe: VSphere 4.1u2 RHEL 6 guest os issue
Please have a look the release note.. http://www.vmware.com/support/vsphere4/doc/vsp_esx41_u1_rel_notes.htmlCheers, Udin
View ArticleRe: Multipath Design with 5 hosts and 3 MD3000i Storage
Julien, Thanks for the reply. I went over the best practices documentation and it all makes sense, however I have 3 storage units instead of 2. Do you think 2 separate sub-nets would still be...
View ArticleRe: Cannot access ESXi 4.1 Console from the LAN
Actually if you are out of this VPN then you can't access this console. Before accessing this console you have to establish a tunnel.Cheers, Udin
View ArticleRe: VLAN not communicating between VMs
Have you route your all VLAN?Also make sure that you have configure access port correctly.Cheers, Udin
View ArticleESXi Service Console : Resource throttling
Hi, We have 2 HP Proliant Servers (ML350 G5 and ML350 G6), each running ESXi free licensed.VM's are on shared storage (SAN, connected via dedicated gigabit, mounted via NFS)jumbo frames are enabled. We...
View ArticleRe: ESXi Service Console : Resource throttling
Is the NFS share mounted using asynchronous or synchronous? You can verify this on the storage device.
View ArticleRe: ESXi Service Console : Resource throttling
Hi, SAN is a Iomega Storcenter ix12-300i.Its webGUI does not let you control or view this NFS-setting. However I do have SSH-access. Could I figure it out that way?
View ArticleRe: PSOD Exception 14 when adding a NIC dual gigabit NC360T
hi abelardocarioca, I hate to be the person to bring the bad news to you, but I highly suspect that your add-on dual port nic card is likely faulty and you need to have a replacement on the nic card....
View ArticleRe: PSOD Exception 14 when adding a NIC dual gigabit NC360T
Hi, If you are using inbox driver, I think you can try async driver if it is not GA build....
View ArticleRe: Multipath Design with 5 hosts and 3 MD3000i Storage
Hi, Do you think 2 separate sub-nets would still be sufficient or should I use 3 sub-nets? Yes, 2 sub-net is sufficient with 3 storage Area. I realized I needed a better diagram to explain my...
View ArticleRe: Multipath Design with 5 hosts and 3 MD3000i Storage
Okay, this photo is the new configuration (physical) wise. Then I would make a vKernal 1, with vSwitch 1 & 3 .. with Round Robin.
View ArticleRe: Multipath Design with 5 hosts and 3 MD3000i Storage
Hi, 2 nics by subnet is sufficient, so remove the third card . And add a redundancy to your mgmt, vmotion and production network. DEV / Network is less important that production network. But in your...
View Article